Add New V3 User" Group; Table 100: Wbm "Configuration Of Snmp V3 Users" Page - "Add New V3 User - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G

7.8.1.34.3 "Add New v3 User" Group

You can enter 10 users.
Table 100: WBM "Configuration of SNMP v3 Users" Page – "Add New v3 User" Group
Parameters
Security Authentication
Name
Authentication Type
Authentication Key (min.
eight char.)
Privacy
Privacy Key (min. eight
char.)
Notification Receiver IP
Click [Add] to add a new user. The changes only take effect after restarting the
controller. For this purpose, use the WBM reboot function. Do not shut down the
controller too early!
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Enter the user name here. This name must be
unique; a pre-existing user name is not accepted
when entered here. The security authentication
name can have a maximum 32 characters, without
any spaces.
Specify the authentication type for the SNMP v3
packets.
Possible values:
- Use no authentication ("None")
- Message Digest 5 ("MD5")
- Secure Hash Algorithm ("SHA")
Specify the authentication key here. This
authentication key must have between eight and 32
characters, without any spaces.
Specify the encryption algorithm for the SNMP
message here.
Possible values:
- No encryption ("None")
- Data Encryption Standard ("DES")
- Advanced Encryption Standard ("AES")
Enter the key for encryption of the SNMP message
here. If nothing is specified here, the "authentication
key" is automatically used. The privacy key must
have between eight and 32 characters, without any
spaces.
Specify an IP address for a trap receiver for v3 traps
here. If no v3 traps are to be sent for this user, this
field remains blank.
Commissioning 153
Manual