Table 299: Description Of The Configuration Scripts For "Networking - Host/Domain Name; Table 300: Description Of The Configuration Scripts For "Networking - Tcp/Ip - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G

Table 299: Description of the Configuration Scripts for "Networking - Host/Domain Name"

Parameters Status Call
Host Name
Host Name
Actual
Hostname
Domain Name
Domain name

Table 300: Description of the Configuration Scripts for "Networking - TCP/IP"

Parameters Status Call
IP Address X1: Determines the IP parameters of the ETHERNET interfaces X1/X2 in
"switched" mode and the ETHERNET interface X1 in "separated" mode
Type of IP
address
configuration
IP address
Subnet Mask
IP Address X2: Determines the parameters currently used for the ETHERNET interface X2 in
"separated" mode
See "IP Address X1." When calling these up, replace X1 with X2 (only permissible in "separated"
mode).
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
get_coupler_details
read
hostname
change_hostname
write
hostname=<String>
get_coupler_details
read
actual-hostname
get_coupler_details
read
domain-name
change_hostname
write
dnsdomain=<String>
get_eth_config
read
X1 config-type
config_interfaces
interface=X1
write
config-type=<Value>
state=enabled
get_eth_config
read
X1 ip-address
config_interfaces
write interface=X1
ip-address=<Value>
get_eth_config
read
X1 subnet-mask
config_interfaces
write interface=X1
subnet-mask=<Value>
Appendix 381
Output/Input
Display of the host name.
The return value is blank when
/etc/hostname is empty.
For details see the parameter
"Actual Hostname."
Changing the host name.
Input a host name for <String>.
The actual host name (if
/etc/hostname is empty, a unique
host name is generated from the
MAC address)
Display of domain name
Change the domain name. Enter
the domain name for <String>.
Output/Input
Path via which the interface
receives its IP address
Possible return values are:
- static (set statically)
- dhcp (per DHC)
- bootp (per BootP)
Enable process, via which the
interface receives its IP address
Possible entries for <Value> are:
- static (set statically)
- dhcp (per DHC)
- bootp (per BootP)
Address set for using a static IP
address (static IP).
Change IP address for static IP
<Value> must have an IP address
with the format
"Number.Number.Number.Numbe
r."
Subnet mask set for using a static
IP address (static IP)
Change subnet mask for static IP
addresses. <Value> must have
an IP address with the format
"Number.Number.Number.Numbe
r."
Effecti
ve
Immedia
tely
Immedia
tely
Immedia
tely
Immedia
tely
Effecti
ve
Immedia
tely
Immedia
tely
Immedia
tely
Manual