Configuration Of Network Services" Page; Table 97: Wbm "Configuration Of Network Services" Page - "Ftp" Group; Table 98: Wbm "Configuration Of Network Services" Page - "Ftpes - WAGO I/O System 750 Manual

198 Appendix

15.2.1.2.14 "Configuration of Network Services" Page

The settings for various services are shown on the "Configuration of Network
Services" page.
Close any ports and services that you do not need!
Unauthorized persons may gain access to your automation system through open
ports.
To reduce the risk of cyber attacks and thus increase cyber security, close all
ports and services not required by your application in the control components
(e.g., port 6626 for WAGO-I/O-CHECK and port 11740 for CODESYS V3).
Only open ports and services during commissioning and/or configuration.
"FTP" Group
Table 97: WBM "Configuration of Network Services" Page – "FTP" Group
Parameter
Service active
Click the [Submit] button to apply a change. The change takes effect
immediately.
"FTPES (explicit FTPS)" Group
Table 98: WBM "Configuration of Network Services" Page – "FTPES (explicit FTPS)" Group
Parameter
Service active
Click the [Submit] button to apply a change. The change takes effect
immediately.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Explanation
Enable/disable the FTP service.
This service is disabled by default.
Explanation
Enable/disable the FTPS service.
This service is disabled by default.
WAGO I/O System 750