Table 74: Wbm "Plc Runtime Configuration" Page - "Webserver Configuration" Group - WAGO I/O System 750 Manual

176 Appendix
"Webserver Configuration" Group
Table 74: WBM "PLC Runtime Configuration" Page – "Webserver Configuration" Group
Parameter
CODESYS V3 Webserver
State
Default Webserver
Click [Submit] to apply the change. The change takes effect immediately.
In its default setting, the WBM is called up when only entering the IP address.
To update the display after switching, enter the IP address again in the address
line of the Web browser.
To display the web visualization, the Webserver must be enabled (in WBM under
"Ports and Services" -> "PLC Runtime Services") and there must be a suitably
configured application.
Regardless of the default Webserver setting, the WBM can be called up at any
time with "https://<IP address>/wbm" and the Web visualization with "https://<IP
address>/webvisu".
Possible error messages when calling up the web visualization
The "500 − Internal Server Error" message indicates that the Webserver is not
enabled.
A page with the header "WebVisu not available" means that no application has
been loaded in the product using web visualization.
Manual
Version 1.7.0, valid from FW Version 04.01.10(23)
750-8210/040-000 PFC200; G2; 4ETH; XTR
Meaning
This displays the status (enabled/disabled) of the
CODESYS V3 Webserver.
Choose here whether the Web-based Management
or web visualization of the runtime system should be
displayed when only entering the IP address of the
controller.
Web-Based The Web-based Management is
Management displayed.
WebVisu The web visualization of the runtime
system is displayed.
WAGO I/O System 750