Configuration Interface - WAGO 750-8 Series Manual

Configuration Interface

6 Configuration Interface
The ConfigWRF06 configuration interface can be used to set the register values
of the WRF06 configuration register.
Note
Configuration Interface
The configuration interface is stored in the "ThermokonWRF06_01.lib"
library. It can be opened via the "Visualization" button
configuration interface must be connected to the instance of
FbWRF06Config using a wildcard character.
Note
Configuration Options
Depending on the WRF06 type, the configuration opens may differ. All
settings are always displayed in the visualization. However, not all settings
will cause a change. For type-specific settings, the WRF06-RS-485
Modbus
Note
Configuration
Before a new configuration is written to the room operating unit, it is
recommended that you load the existing configuration from the room
operating unit via the [Read] button to check the current settings.
To make the settings on the interface, the "xEnable" input of the
FbWRF06Config function block in the project is set to "TRUE".
Anwendungshinweis
®
protocol description from Thermokon should be used.
13
. The