WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
15.2.1.2.7 "Configuration of Service Interface" Page
The settings for the service interface are shown on the "Configuration of the
Service Interface" page.
"Service Interface assigned to" Group
The application that the service interface is currently assigned to is displayed.
"Assign Owner of Service Interface" Group
You can specify the application to which the service interface is assigned after
the next controller reboot.
Table 88: WBM "Configuration of Service Interface" Page – "Assign Owner of Service Interface"
Group
Parameters
WAGO Service
Communication
Linux Console
Unassigned (usage by
applications, libraries,
CODESYS)
Click [Submit] to apply the change. The change only takes effect once the
controller restarts. For this purpose, use the WBM reboot function. Do not shut
down the controller too early!
Explanation
Specify that the service interface is used for the
WAGO Service communication or runtime system
communication.
Specify that the service interface is assigned to the
®
Linux
console.
Specify that the service interface is not to be
assigned to any application and is available, so that
the CODESYS program, for example, can access it
via function blocks.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 189
Manual