Scan Motor (M1) - Toshiba e-STUDIO2330C Service Manual

7.6.6

Scan motor (M1)

(1) Take off the upper rear cover.
 P.3-32 "3.5.17 Upper rear cover"
(2) Take off the rear cover-2.
 P.3-33 "3.5.19 Rear cover-2"
(3) Disconnect 1 connector.
(4) Release the harness from the harness
clamp.
(5) Remove 3 screws and take off the scan
motor with the whole bracket.
Note:
When installing the scan motor, be sure to
perform the belt tension adjustment.
 P.7-31 "7.7.2 Belt tension adjustment of
the Scan motor"
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 7-33
Screw
Fig. 7-34
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
7 - 21
Connector
Scan motor
SCANNER
7