3.7.2
Belt tension adjustment of the Scan motor
(1)
Hook the belt tension jig to the motor bracket
and the flame.
(2)
Loosen screw-A and -C. (There is no need to
loosen screw-B, since it is a shoulder screw.)
(3)
The scan motor is pulled by the belt tension
jig. Fix screw-A and then -C at the stopped
position.
(4)
Remove the belt tension jig.
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
Timing belt
A B
Pully
C
Fig. 3-32
Belt tension jig
Fig. 3-33
3 - 71
Belt tension jig
Scan motor
e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3