Adjustment Of The Finisher (Mj-1022) - Toshiba e-STUDIO230L Service Handbook

3.12 Adjustment of the Finisher (MJ-1022)

3.12.1 Adjusting the jogging plate width
<Procedure>
(1) Remove the right inner cover and the rear cover.
(2) Adjust the front jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in
".
• Press SW2 twice on the finisher controller
PC board.
- The front jogging plate moves to the
home position.
(3) Adjust the rear jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in
".
• Press SW2 twice on the finisher controller
PC board.
- The rear jogging plate moves to the
home position.
(4) Measure the jogging width (standard at 317 mm).
e-STUDIO200L/202L/203L/230/232/233/280/282/283
ADJUSTMENT
P.3-84 "Fig. 3-109
P.3-84 "Fig. 3-110
Jogging width
3 - 84
ON
1 2 3 4 5
Fig. 3-109
ON
1 2 3 4 5
Fig. 3-110
Rear jogging plate
home position
317mm
Fig. 3-111
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
6 7 8
6 7 8
Front jogging plate
home position