Finisher Firmware (Mj-1101) - Toshiba e-STUDIO2330C Service Manual

20.3.3

Finisher firmware (MJ-1101)

Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
operated properly.
[A] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment.
(3) Remove 1 screw and take off the board access cover.
(4) Connect the download jig with the jig connector (CN9) on the Finisher control board.
(5) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.
Updating starts and the LED on the download jig lights
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
Board access cover
Fig. 20-20
Download jig
Fig. 20-21
20 - 36
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved