5.4 Automatic Detection of Connected Motor
5.4
Automatic Detection of Connected Motor
You can use a SERVOPACK to operate either a Rotary Servomotor or a Linear Servomotor.
If you connect the Servomotor encoder to the CN2 connector on the SERVOPACK, the SER-
VOPACK will automatically determine which type of Servomotor is connected. Therefore, you
normally do not need to specify the motor type.
Information
5-14
If an encoder is not connected, e.g., for a test without a motor, you can specify a Rotary Ser-
vomotor or a Linear Servomotor in Pn000 = n.X (Rotary/Linear Servomotor Startup
Selection When Encoder Is Not Connected). If you specify either a Rotary or Linear Servomo-
tor, only the parameters, monitors, alarms, and functions for the specified motor type will be
enabled.
Parameter
n.0
(default setting)
Pn000
n.1
Meaning
When an encoder is not connected,
start as SERVOPACK for Rotary Servo-
motor.
When an encoder is not connected,
start as SERVOPACK for Linear Servo-
motor.
When Enabled
Classification
After restart
Setup