YASKAWA SGD7S Product Manual page 467

Problem Possible Cause
Noise interference occurred
because the Encoder Cable
is too long.
Noise interference occurred
because the Encoder Cable
is damaged.
The Encoder Cable was sub-
jected to excessive noise
interference.
There is variation in the FG
Abnormal
potential because of the
Noise from
influence of machines on the
Servomotor
Servomotor side, such as a
welder.
There is a SERVOPACK
pulse counting error due to
noise.
The encoder was subjected
to excessive vibration or
shock.
A failure occurred in the
encoder.
A failure occurred in the
Serial Converter Unit.
A failure occurred in the linear
encoder.
12.5 Troubleshooting Based on the Operation and Conditions of the Servomotor
Confirmation
Check the length of the
Encoder Cable.
Check the Encoder Cable
to see if it is pinched or
the sheath is damaged.
Check to see if the
Encoder Cable is bundled
with a high-current line or
installed near a high-cur-
rent line.
Check to see if the
machines are correctly
grounded.
Check to see if there is
noise interference on the
signal line from the
encoder.
Check to see if vibration
from the machine
occurred. Check the Ser-
vomotor installation
(mounting surface preci-
sion, securing state, and
alignment).
Check the linear encoder
installation (mounting sur-
face precision and secur-
ing method).
–
–
–
Continued from previous page.
Correction Reference
• Rotary Servomotors:
The Encoder Cable
length must be 50 m
max.
• Linear Servomotors:
Make sure that the
Serial Converter Unit –
cable is no longer
than 20 m and that
the Linear Encoder
Cable and the Sensor
Cable are no longer
than 15 m each.
Replace the Encoder
Cable and correct the
–
cable installation envi-
ronment.
Correct the cable lay-
out so that no surge is
–
applied by high-current
lines.
Properly ground the
machines to separate
–
them from the FG of
the encoder.
Implement counter-
measures against noise
–
for the encoder wiring.
Reduce machine vibra-
tion. Improve the
mounting state of the
–
Servomotor or linear
encoder.
Replace the Servomo-
–
tor.
Replace the Serial Con-
–
verter Unit.
Replace the linear
–
encoder.
Continued on next page.
12
12-61