YASKAWA SGD7S Product Manual page 354

8.13 Manual Tuning
8.13.1 Tuning the Servo Gains
Model Following Control
You can use model following control to improve response characteristic and shorten position-
ing time. You can use model following control only with position control.
Normally, the parameters that are used for model following control are automatically set along
with the servo gains by executing autotuning or custom tuning. However, you must adjust them
manually in the following cases.
• When the tuning results for autotuning or custom tuning are not acceptable
• When you want to increase the response characteristic higher than that achieved by the tun-
ing results for autotuning or custom tuning
• When you want to determine the servo gains and model following control parameters yourself
The block diagram for model following control is provided below.
Speed
Speed pattern
Host controller
(Not provided by Yaskawa)
 Manual Tuning Procedure
Use the following tuning procedure for using model following control.
Step
1
2
3
4
8-88
Movement
Model following
reference
control
mKp, mVFF, mTFF
Time
Position control loop
+
Position
Deviation

loop gain
counter
Position loop
Friction compensation must also be used. Set the friction compensation parameters. Refer to the
following section for the setting procedure.
8.12.2 Friction Compensation on page 8-70
Adjust the servo gains. Refer to the following section for an example procedure.
Tuning Procedure Example (for Position Control or Speed Control) on page 8-81
Note: 1. Set the moment of inertia ratio (Pn103) as accurately as possible.
2. Refer to the guidelines for manually tuning the servo gains and set a stable gain for the position loop gain
(Pn102).
Guidelines for Manually Tuning Servo Gains on page 8-86
Increase the model following control gain (Pn141) as much as possible within the range in which
overshooting and vibration do not occur.
If overshooting occurs or if the response is different for forward and reverse operation, fine-tune
model following control with the following settings: model following control bias in the forward direc-
tion (Pn143), model following control bias in the reverse direction (Pn144), and model following con-
trol speed feedforward compensation (Pn147).
Speed
feedforward
Speed control loop
Speed
reference +
Speed control

section
Kp Kv and Ti
Speed loop
SERVOPACK
Kp: Position loop gain (Pn102)
Kv: Speed loop gain (Pn100)
Ti: Speed loop integral time constant (Pn101)
Tf: First stage first torque reference filter time constant (Pn401)
mKp: Model following control gain (Pn141)
mTFF: Model following control bias in the forward direction (Pn143)
Model following control bias in the reverse direction (Pn144)
mVFF: Model following control speed feedforward compensation (Pn147)
Description
Torque feedforward
Servomotor
+
Current
Tf
Power

control
converter
section
Current loop
M
PG
Encoder