Interpreting Panel Displays; Interpreting Status Displays; Alarm And Warning Displays; Hard Wire Base Block Active Display - YASKAWA SGD7S Product Manual

14.1 Interpreting Panel Displays

14.1.1 Interpreting Status Displays

14.1 Interpreting Panel Displays
You can check the Servo Drive status on the panel display of the SERVOPACK.
Also, if an alarm or warning occurs, the alarm or warning number will be displayed.
14.1.1 Interpreting Status Displays
The status is displayed as described below.
Display

14.1.2 Alarm and Warning Displays

If there is an alarm or warning, the display will change in the following order.
Example: Alarm A.E60
Status Display

14.1.3 Hard Wire Base Block Active Display

If a hard wire base block (HWBB) is active, the display will change in the following order.
Status Display

14.1.4 Overtravel Display

If overtravel has occurred, the display will change in the following order.
Forward Overtravel (P-OT)
Status Display

14.1.5 Forced Stop Display

During a forced stop, the following display will appear.
Status
Display
14-2
Meaning
/TGON (Rotation Detection) Signal Display
Lit if the Servomotor speed is higher than the
setting of Pn502 or Pn581 and not lit if the
speed is lower than the setting. (The default set-
-1
ting is 20 min or 20 mm/s.)
Base Block Display
Lit during the base block state (servo OFF). Not
lit while the servo is ON.
Not lit. Not lit.
Not lit. Not lit.
Reverse Overtravel (N-OT)
Status Display
Not lit. Not lit.
Display
Reference Input Display
Lit while a reference is being input.
Control Power Supply ON Display
Lit while the control power is being supplied.
Not lit. Not lit.
Not lit. Not lit.
Forward and Reverse Overtravel
Status Display
Not lit. Not lit.
Meaning
Not lit.
Not lit.