Table of Contents
Advertisement
5.4.1 Removing the Nose
Piece
Figure 5-1 Remove large screws and nose piece (3 on each side)
TIENet™ 360 LaserFlow Ex™ Velocity Sensor
Section 5 Maintenance and Optional Kits
The screws that attach the nose piece to the body are difficult to
access with a straight screwdriver, being somewhat obstructed by
the mounting block.
1. Remove the 6 large Phillips screws on the LaserFlow Ex
nose piece, and separate the nose from the body. Do not
remove any other screws.
5-3
Advertisement
Table of Contents
