BRAKE SYSTEM (Standard)
Install the pad spring onto the caliper body properly
as shown (page 15-37).
Check the caliper and bracket pin boots and replace
them if they are hard, deteriorated or damaged.
Install the boots into the caliper and bracket.
Apply silicone grease to the inside of the boots and
install the caliper bracket over the caliper body.
Install the brake pads (page 15-13).
Tighten the pad pin
after installing the
caliper onto the fork
leg.
INSTALLATION
RIGHT CALIPER
RAKE HOSES
Install the right brake caliper so the disc is posi-
tioned between the pads, being careful not to dam-
age the pads.
Install new mounting bolts and tighten them.
TORQUE: 31 N·m (3.2 kgf·m, 23 lbf·ft)
Install the wheel speed sensor with the wire clamp
and tighten the bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the wire clamp onto the fork leg and tighten
the bolt.
15-32
RIGHT FRONT RAKE CALIPER
OIL OLTS
SEALING WASHERS
RACKET
OOT
PAD SPRING
CLAMP
WHEEL SPEED SENSOR
CLA P
CALIPER
OOT
CLAMP
OUNTING
BOLTS
CLA P
SPEED
SENSOR