Delay Valve Removal; Delay Value Installation; Valve (Pcv) - Honda GL1800 Service Manual

BRAKE SYSTEM (Standard)
Connect the brake hoses to the caliper with the oil
bolts and new sealing washers as shown, and
tighten the oil bolts.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Tighten the pad pin and install the pad pin plug.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Fill and bleed the pedal brake hydraulic system
(page 15-11).
Install the rear wheel (page 14-14).
DELAY VALVE
REMOVAL
Drain the brake fluid from the brake pedal hydraulic
system (page 15-6).
Remove the following:
When removing the
– clips
oil bolt and joint
– oil bolts, sealing washers and brake hoses
nut, cover the ends
– bolt and 3-way joint
of the hoses and
– brake pipe (by loosening joint nut, being careful
pipe to
not to scratch the fender)
prevent
– mounting bolts (8 mm head and 10 mm head;
contamination.
fender bolt)
– delay valve
INSTALLATION
Install the delay valve onto the fork leg and tighten
Route the speed
the mounting bolts.
sensor wire prop-
erly (page 1-23).
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Apply brake fluid to the joint nut threads on the
brake pipe.
Connect the brake pipe by tightening the joint nut.
TORQUE: 17 N·m (1.7 kgf·m, 12 lbf·ft)
Install the 3-way joint and tighten the bolt.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the brake hoses with the oil bolts and new
sealing washers, and tighten the oil bolts.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Secure the speed sensor wire with the clips.
Fill and bleed the pedal brake hydraulic system
(page 15-10).
15-38
OIL BOLTS
JOINT NUT
-WAY JOINT
BRAKE PIPE
-WAY
JOINT
OIL BOLTS
BRAKE HOSES
LIPS
DELAY VALVE
DELAY
VALVE
SEALING
WASHERS