Connect the brake hoses to the caliper with the oil
bolts and new sealing washers.
Push the stopper or the brake hose eyelet joint
against the caliper body, then tighten the oil bolts to
the specified torque.
TORQUE: 34 N•m (3.5 kgf-m, 25 lbf•ft)
Install the brake pads (page 15-15).
Fill and bleed the hydraulic system (page 15-7).
After installation, check the air gap (page 16-24).
FRONT BRAKE CALIPER (CB600F}
REMOVAL
Drain the brake fluid from the front brake -hydraulic
system (page 15-13).
Remove the brake pads (page 15-16).
Remove the oil bolt and sealing washers.
Remove the mounting bolts and brake caliper.
DISASSEMBLY
Remove the caliper bracket from the caliper body.
HYDRAULIC BRAKE
CALIPER BRACKET
CALIPER BODY
15-37