Cruise/Reverse Control Module System Inspection - Honda GL1800 Service Manual

Shift the transmission into neutral and turn the igni-
tion switch to "ON."
Push the reverse shift switch to "ON" to move the
reverse actuator pulley to the reverse position.
Make sure there is clearance between the reverse
shift arm and lost motion plate as shown.
Push the reverse shift switch to "OFF" to return the
reverse actuator pulley to the neutral position.
Turn the ignition switch to "OFF" and install the
following:
– center inner fairing (page 2-6)
– right engine side cover (page 2-5)
CRUISE/REVERSE CONTROL MODULE
SYSTEM INSPECTION
Remove the top shelter (page 2-11).
Turn the ignition switch to "OFF" and disconnect
the 26P black and gray connectors from the cruise/
reverse control module.
Check the reverse system circuits at the wire har-
ness side connector terminals by referring to the
chart on page 19-40.
STARTER/REVERSE SYSTEM
EVE SE SHIFT ACTUATO
PULLEY ( EVE SE POSITION)
learance should appear
REVERSE
SHIFT ARM
LOST MOTION PLATE
19-39