Honda GL1800 Service Manual page 330

Stake the lock nut into the countershaft groove in
Be careful not to
two places.
damage the
countershaft
threads.
Install the oil separate plate and tighten the two
bolts.
Apply engine oil to the needle bearing in the pri-
mary driven gear boss.
Install the oil pump driven sprocket, drive chain and
driven gear boss as a set with the "OUT" mark of
the sprocket facing out.
Apply locking agent to the threads of the driven
sprocket bolt and install it.
Temporarily install the clutch outer on the driven
gear boss.
Hold the clutch outer with the special tool and
tighten the sprocket bolt.
TOOL:
Clutch outer holder
TORQUE: 18 N·m (1·8 kgf·m, 13 lbf·ft)
GEARSHIFT LINKAGE/TRANSMISSION
CHAIN
LUT H
OUTER
07JMB-MN50100
take
IL SEPARATE PLATE
SPROCKET
("OUT")
BOLT
LUT H OUTER HOLDER
10-21
DRIVEN
GEAR
BOSS