Ignition Cruise Relay Inspection - Honda GL1800 Service Manual

Terminal No. &
Circuit
35 Brake light
39 Cruise actua-
tor motor B
45 Cruise actua-
tor motor C
50 Cruise actua-
tor relay coil
52 Ground
* Measure the voltage using the peak voltage tester (U.S.A. only) or peak voltage adaptor (07HGJ-0020100/not available
in U.S.A.) with commercially available digital multimeter (impedance 10 MΩ/DCV minimum).
IGNITION CRUISE RELAY
INSPECTION
Remove the seat (page 2-5).
Remove the two screws and remove the relay box.
Remove the relay blocks from the relay box.
1. Turn the ignition switch to "OFF" and remove
the ignition cruise relay and cruise actuator
relay.
2. Check the Black/yellow wire for continuity
between the ignition cruise relay and cruise actu-
ator relay.
There should be continuity.
Wire Color &
Connection
Green/red (+) and Ignition switch turned to "ON"
ground (–) Brake lever and pedal free
Ignition switch turned to "ON"
Brake lever squeezed or brake pedal
depressed
Yellow and No. 32
Brown/white
Light green and No.
32 Brown/white
Green/black (+) and Ignition switch turned to "ON"
ground (–)
Green and ground
CRUISE CONTROL SYSTEM
Conditions
–
–
–
RUISE A TUATOR
RELAY ONNE TOR
Specification
There should be no voltage.
There should be battery
voltage.
There should be 3 – 7Ω.
There should be 3 – 7Ω.
There should be battery
voltage.
There should be continuity.
ELAY BOX
IGNITION RUISE
RELAY ONNE TOR
21-11