BATTERY/CHARGING SYSTEM
WIRE HARNESS INSPECTION
Remove the left side cover (page 2-5).
Remove the left engine side cover (page 2-5).
Disconnect the battery negative (–) cable from the
Be sure to discon-
battery.
nect the battery
Pull the rubber cap off the alternator terminal,
negative cable to
remove the nut and disconnect the alternator cable.
prevent sparking
Disconnect the alternator 4P connector.
when disconnect-
ing or connecting
Connect the battery negative cable to the battery
the alternator cable.
and check the following at the wire harness side:
BATTERY CHARGING LINE
Measure the voltage between the alternator cable
terminal (+) and ground (–).
There should be battery voltage at all times.
BATTERY VOLTAGE LINE
Measure the voltage between the Black/yellow wire
terminal (+) of the alternator 4P connector and
ground (–).
There should be battery voltage with the ignition
switch turned to "ON" and the engine stop switch
turned to "
Install the removed parts in the reverse order of
removal.
ALTERNATOR
REMOVAL
Remove the left engine side cover (page 2-5).
Remove the fuel tank (page 5-56).
Disconnect the alternator 4P connector.
Pull the rubber cap off the alternator terminal,
remove the nut and disconnect the alternator cable.
Remove
alternator.
17-10
."
the
three
mounting
bolts
and
the
P CONNECTOR
NUT, CABLE
P CONNECTOR
NUT, CABLE
MOUNTING BOLTS
LTERN TOR