CLUTCH
Apply grease to the lips of a new oil seal and install
it into the crankcase.
Install the lifter rod.
Install the dowel pins.
Install the slave cylinder onto the gearshift linkage
cover and tighten the mounting bolts.
Connect the clutch hose with the oil bolt and new
sealing washers by aligning the hose joint with the
groove in the slave cylinder.
Tighten the oil bolt.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill
and
(page 9-7).
CLUTCH
CLUTCH COVER REMOVAL
Drain the engine oil (page 3-16).
Remove the exhaust system (page 2-18).
Remove the radiator reserve tank (page 6-8).
Remove the following:
– fuel tank drain tube from clamp
– eleven bolts and clamp
– clutch cover
– two dowel pins
– oil through pipe and O-ring
– scavenge oil strainer
9-14
bleed
the
clutch
hydraulic
OIL SEAL
M UNTING B LTS WASHERS
system
SLAVE
CYLINDER
CLAMP
I E AND O-RING
STRAINER
OWEL PINS
RO
IL B LT
OLTS
CLUTCH
COVER
DOWEL
INS