Honda GL1800 Service Manual page 500

Hide thumbs Also See for GL1800:

Table of Contents

Apply grease to the pivot shaft groove of the pivot

Place the master cylinder/pivot arm assembly into

the frame while pushing the water hose aside and

insert the pivot arm into the pivot hole, being care-

ful not to damage its splines.

Install the master cylinder onto the frame and

tighten the mounting bolts.

TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)

Install the return spring into the pivot arm and onto

the frame stopper pin.

Apply brake fluid to a new O-ring and install it onto

the reservoir joint.

Install the reservoir hose joint into the master cylin-

Make sure the snap

der and secure it with the snap ring.

ring is firmly seated

in the groove.

Connect the brake hose to the master cylinder with

the oil bolt and new sealing washers, and tighten

the oil bolt.

TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)

Install the brake pedal by aligning the slit with the

punch mark on the pivot arm.

Install the pinch bolt and tighten it.

TORQUE: 26 N·m (2.7 kgf·m, 20 lbf·ft)

BRAKE SYSTEM (Standard)

Troubleshooting