Rear Wheel Removal; Rear Brake Disc Replacement - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

REAR WHEEL/SUSPENSION

REAR WHEEL REMOVAL

Remove rear fender A (page 2-13).

Set the rear wheel on the ground and loosen the

five rear axle nuts while applying the rear brake.

Put the motorcycle on its center stand and support

the motorcycle securely.

Remove the five rear wheel nuts.

Move the rear wheel to the left to separate it from

the final gear case and remove the rear wheel.

Remove the rear wheel (page 14-14).

Remove the following:

– bolt and brake hose clamp

– two bolts and brake caliper

– two screws (using an impact driver)

– brake disc

– ABS model only: six bolts and pulser ring if

Install a new pulser ring with new bolts and tighten

TORQUE: 8 N·m (0.8 kgf·m, 5.8 lbf·ft)

Clean the mating surfaces of the final drive assem-

bly and brake disc, and make sure that no foreign

materials are allowed.

Install a new brake disc onto the stud bolts.

Install new screws and tighten them.

TORQUE: 9 N·m (0.9 kgf·m, 6.5 lbf·ft)

Install the brake caliper with new bolts and tighten

TORQUE: 45 N·m (4.6 kgf·m, 33 lbf·ft)

Install the brake hose clamp onto the gear case and

tighten the bolt.

TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)

For rear wheel installation, see page 14-14.

After installing the rear wheel, check the rear wheel

speed sensor air gap (page 16-29).