Apply engine oil to the threads and seating surface
of a new lock nut, and install it.
Shift the transmission into any gear except neutral.
Apply the rear brake and tighten the lock nut.
TORQUE: 127 N·m (13.0 kgf·m, 94 lbf·ft)
If the engine was removed from the frame, hold the
output shaft with the special tool and tighten the
lock nut.
TOOL:
Shaft holder
Stake the lock nut into the mainshaft groove.
Be careful not to
damage the
mainshaft threads.
Apply engine oil to the sliding surface of the lifter
joint piece.
Install lifter plate A and secure it with the stopper
Make sure the stop-
ring.
per ring is seated
securely.
CLUTCH COVER INSTALLATION
Apply grease to the lips of a new lifter joint piece oil
seal.
Install the oil seal into the clutch cover with the flat
side facing up until the snap ring groove is visible.
Install the snap ring into the cover groove securely.
TOOL:
Pilot, 17 mm
Driver
07PAB-0010200 or
07924-PJ40001
(U.S.A. only)
07746-0040400
07749-0010000
SNAP RING
IL SEAL
CLUTCH
9-25