Crankcase Cover Bearing Replacement - Honda GL1800 Service Manual

CRANKCASE COVER BEARING
REPLACEMENT
Remove the bolts and bearing setting plates.
Heat the crankcase cover to 80° C (176° F) and
remove the needle bearing of the reverse shifter
shaft from the rear crankcase cover using the spe-
cial tools.
Drive the other bearings out of the crankcase cover.
TOOLS:
Bearing remover, 12 mm
Remover shaft
Remover weight
Remove the alternator driven gear bearing from the
crankcase.
Drive a new alternator driven gear bearing in the
crankcase with the sealed side facing in.
TOOLS:
Driver
Attachment, 42 x 47 mm
Pilot, 20 mm
Drive the following bearings into the crankcase
cover with the markings facing up. Use new
bearings.
TOOLS:
Output shaft:
Driver
Attachment, 62 x 68 mm
Pilot, 30 mm
Alternator driven gear:
Driver
Attachment, 42 x 47 mm
Pilot, 25 mm
Reverse shifter shaft:
Driver
Pilot, 16 mm
GEARSHIFT LINKAGE/TRANSMISSION
EVE SE SHIFTE SHAFT
07936-1660110
07936-1660120 or
07936-166010A
OUTPUT SHAFT
(U.S.A. only)
07741-0010201 or
07936-371020A or
07936-3710200
(U.S.A. only)
07749-0010000
07746-0010300
07746-0040500
07749-0010000
07746-0010500
07746-0040700
07749-0010000
07746-0010300
07746-0040600
07749-0010000
07746-0041300
P IMA Y D IVEN GEA
LTERN TOR DRIVEN
GE R BE RING
ALTE NATO
D IVEN GEA
DRIVER
ATTACHMENT
ILOT
10-19