BRAKE SYSTEM (Standard)
If the push rod joint is reinstalled, adjust the push
rod length so the distance from the center of the
lower mounting bolt hole to the center of the joint
pin hole is 106 mm (4.2 in) After adjustment, tighten
the joint nut.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
Install the pivot arm into the master cylinder push
rod joint with the joint pin and a new cotter pin.
INSTALLATION
IGHT FOOTPEG
15-22
MASTE CYLINDE /PIVOT
A M ASSEMBLY
ETU N SP ING
B AKE PEDAL
06 mm
OTTER PIN
JOINT PIN
PIVOT ARM
OIL BOLT
SEALING WASHE S
O- ING
SNAP ING
B AKE LIGHT/C UISE CANCEL
SWITCH ASSEMBLY