Front Brake Caliper; Cbs Front Brake - Honda CB HORNET 160R 2015 Shop Manual

BRAKE SYSTEM

FRONT BRAKE CALIPER

CBS FRONT BRAKE

REMOVAL
Drain the brake fluid from the hydraulic system (page 14-3).
Remove the brake pads (page 14-7).
Remove the brake hose by removing the oil bolt and
sealing washer.
Remove the brake caliper mounting bolts and brake caliper.
DISASSEMBLY
Remove the caliper bracket from the caliper body.
Remove the pad spring and bracket pin boot from the
caliper body.
Remove the pad retainer and caliper pin boot from the
caliper bracket.
If the bracket pin boot is hard or deteriorated, replace it
with a new one.
Do not use high
Place a shop towel over the caliper pistons.
pressure air or
Position the caliper body with the piston down, and apply
bring the
small squirts of air pressure to the fluid inlet to remove the
nozzle too close
caliper pistons.
to the inlet.
Be careful not to
Push the dust seals and piston seals in, and lift them out.
damage the
Clean the seal grooves, caliper piston sliding surfaces and
piston
caliper pistons with clean brake fluid.
sliding surface.
14-14
OIL BOLT
SEALING WASHERS
CALIPER
PAD RETAINER
BODY
BRACKET
PIN BOOT
PISTON SEAL
BOLTS
CALIPER BRACKET
CALIPER
PIN BOOT
PAD SPRING
DUST SEAL