Honda GL1800 Service Manual page 566

BATTERY/CHARGING SYSTEM
Install the stator coil and regulator/rectifier assem-
HOLE
bly into the rear housing, while inserting the pin
holding the brushes into the hole in the housing.
Align the marks on the rear housing and stator.
EA HOUSING
PIN
Install the three screws and tighten them securely.
+4-9
UT CAP
Install the terminal and nut, and tighten the nut.
TORQUE: 8 N·m (0.8 kgf·m, 5.8 lbf·ft)
Install the terminal cap.
TERMI AL SET
Apply grease to a new oil seal lip and install it into
IL SEAL
the front housing.
17-17