Honda GL1800 Service Manual page 332

Apply engine oil to the needle bearing and sprag
clutch contacting surfaces.
Install the bearing and the starter driven gear while
turning gear clockwise.
Install the starter clutch assembly, washer and bolt.
The final starter
clutch bolt has left-
hand threads.
Temporarily install the clutch outer on the primary
driven gear boss.
Hold the clutch outer with the special tool and
tighten the starter clutch bolt.
TOOL:
Clutch outer holder
TORQUE: 74 N·m (7.5 kgf·m, 54 lbf·ft)
Install the alternator driven gear assembly while
aligning the scissors gears (alternator drive gear
and sub-gear) by inserting the screwdriver into the
gear holes.
Install the friction spring and washer with the con-
cave side of the spring facing in.
GEARSHIFT LINKAGE/TRANSMISSION
STARTER CLUTCH ASSEM LY
LUT H
07JMB-MN50100
OUTER
HOLDER
OLT
Left-hand
threads
WASHER
LUT H
OUTER
10-23