STARTER/REVERSE SYSTEM
Remove the nuts and reverse shift actuator cables
from the cable holder, and disconnect the cables
from the actuator pulley.
Remove the three bolts and the reverse shift actua-
tor from the crankcase.
Install the reverse shift actuator onto the crankcase
and tighten the three bolts securely.
Connect the R (reverse) cable to the pulley on the
"R" mark side and N (neutral) cable on the "N"
mark side.
Install and tighten the lock nuts.
Adjust the actuator cables.
Install the following:
– ABS modulators (page 16-31)
– right engine side cover (page 2-5)
REVERSE SHIFT ACTUATOR CABLE
ADJUSTMENT
Remove the following:
– right engine side cover (page 2-5)
– center inner fairing (page 2-10)
Check that the reverse shift actuator pulley is in the
neutral position as shown.
Check the N cable clearance between the cable
outer end and cable holder.
CLEARANCE: 0 mm (0 in)
Check the R cable clearance between the cable outer
end and cable holder.
CLEARANCE: 0.3 – 0.8 mm (0.01 – 0.03 in)
Loosen each lock nut and adjust the clearance by
turning each adjusting nut as required.
19-38
N CABLE
"N" MARK
R CABLE
"R" MARK
EVE SE SHIFT ACTUATO
PULLEY ( EVE SE POSITION)
DJUSTING NUTS
PULLEY
BOLTS
LOCK NUTS