Front Brake Caliper - Honda INTERCEPTOR 2002 Service Manual

Tighten the oil bolt
while pushing the
brake hose eyelet
joint against the
stopper on the
servo proportional
control valve.
Remove the oil pipe joint nuts.
Remove the mounting bolts and rear proportional
control valve.
Installation is in the reverse order of removal.
Fill and bleed the brake system (page 15-7).
S ERVO PROPORTIONAL CONTROL
VALVE REMOVAL/ INSTALLATION
Drain the pedal and servo li ne hydraulic system
(page 15-7).
Remove t he rear fender (page 2-17).
Remove the oil bolt, sealing washers and brake
hose eyelet from the servo proportional control
valve.
Loosen the oil pipe nut and remov e the oil pipe.
Remove the two mounting bolts and servo propor-
tional control valve.
Installatio n is in the reverse order of removal.
Fill and bleed the brake system (page 15-7).
FRONT BRAKE CALIPER
LEFT CALIPER REMOVAL
Drain the lever and pedal brake line hydraulic sys-
tem (page 15-7).
Avoid spilling fluid
Remove the oil bolts, sealing washers and brake
on painted, plastic,
hose eyelet joints.
or rubber parts.
Remove the secondary master cylinder joint bolt
Place a shop towel
and caliper pivot bolt.
over these parts
whenever the sys-
tem is serviced.
HYDRAULIC BRAKE
15-35