Honda GL1800 Service Manual page 409

FRONT WHEEL/SUSPENSION/STEERING
Apply grease to the throttle grip pipe flange and
sliding surface.
Connect the throttle cables to the throttle grip pipe
Route the cables
flange and install the throttle grip onto the
properly
handlebar.
(page 1-23).
Install the right handlebar switch, aligning its locat-
ing pin with the hole in the right handlebar.
Install the setting plate and tighten the screw.
Install the right handlebar switch screws.
Tighten the forward screw first, then the rear screw.
Install the brake master cylinder and holder.
Align the end of the master cylinder with the punch
mark on the handlebar and temporarily tighten the
holder bolts.
13-14
IN
HOLE
CREW
PLATE
+4-9
OLDER
BOLTS