Speed Limiter Relay System Inspection - Honda GL1800 Service Manual

3. Turn the ignition switch to "OFF" and disconnect
the reverse resistor connector.
With the jumper wire ground, turn the ignition
switch to "ON."
Check for continuity between the Red and White
wire terminals of the wire harness side reverse
resistor connector.
There should be continuity.
• If there is no continuity, check for an open cir-
cuit in the Red and White wires between
power control relay 2 and the reverse resistor.
OPERATION CHECK
Remove the power control relay.
Connect an ohmmeter and a fully charged 12-V bat-
tery to the relay terminals as shown.
There should be continuity while the battery is
connected, and no continuity when the battery is
disconnected.
SPEED LIMITER RELAY
SYSTEM INSPECTION
Remove the following:
– top shelter (page 2-11)
– left saddlebag (page 2-15)
Shift the transmission into neutral and turn the igni-
tion switch to "ON."
Push the reverse shift switch to "ON" and check
that the reverse indicator comes on.
Turn the ignition switch to "OFF" and disconnect
the cruise/reverse
connector.
1. Ground the Gray wire terminal of the control
module connector with a jumper wire.
Turn the ignition switch to "ON" and check that
the speed limiter relay clicks.
• If the relay clicks, the relay coil is normal; go
to step 3.
• If the relay does not click, go to step 2.
control module 26P gray
STARTER/REVERSE SYSTEM
EVE SE ESISTO CONNECTO
CRUISE/REVERSE
CONTROL MODULE
P GRAY CONNECTOR
ray
CONTROL MODULE 26P RAY CONNECTOR
(viewed from the terminal side)
19-33