STARTER/REVERSE SYSTEM
2. Turn the ignition switch to "OFF."
Exchange the speed limiter relay with a known-
The speed limiter
good one and check again.
relay is the same
part as power con-
• If the relay clicks, replace the speed limiter
trol relays 1 and 2.
relay with a new one and go to step 3.
• If the relay does not click, check the following:
– open circuit in the Gray wire between the
– open circuit in the White/blue wire between
3. Turn the ignition switch to "OFF" and disconnect
the reverse resistor connector.
Check for continuity between the White wire ter-
minals of the speed limiter relay and reverse
resistor connectors.
There should be continuity.
OPERATION CHECK
Remove the speed limiter relay.
Connect an ohmmeter and a fully charged 12-V bat-
tery to the relay terminals as shown.
There should be continuity while the battery is
connected, and no continuity when the battery is
disconnected.
REVERSE SHIFT RELAY
Check that the neutral indicator comes on when the
ignition switch is turned to "ON" with the transmis-
sion in neutral.
Remove the seat (page 2-5).
Remove the two screws and remove the relay box.
Remove the relay blocks from the relay box.
19-34
speed limiter relay and cruise/reverse con-
trol module.
the speed limiter relay and reverse shift
actuator (reverse position switch)
PEED LIMITER RELAY
REVER E RE I TOR CONNECTOR
ELAY BOX