Abs Modulator Removal - Honda GL1800 Service Manual

ABS MODULATOR
REMOVAL
Drain the hydraulic brake system (page 15-6).
Remove the ignition coils (page 18-8).
Disconnect the control motor 2P (black) and crank
angle sensor 3P (gray) connectors from each
modulator.
Loosen the joint nuts to disconnect the brake pipe
When loosening
from each modulator.
the joint nuts, cover
the ends of the
Remove the following:
brake pipe to pre-
– spark plug wire clip from stay
vent contamination.
– two stay bolts
– modulator/stay assembly from frame
Be careful not to
– three mounting bolts and each modulator from
bend or damage
the stay
the brake pipe and
stay.
BRAKE SYSTEM (ABS)
16-31