Honda GL1800 Service Manual page 633

STARTER/REVERSE SYSTEM
Apply molybdenum disulfide grease to the inner
and outer surfaces of the spring bushing.
Install the bushing, reverse shift arm spring and lost
motion plate.
Install the reverse shift arm and lost motion spring
over the shaft and plate while hooking the spring
ends properly as shown.
Apply locking agent to the reverse shifter shaft bolt
threads.
Install the collar, washer and shaft bolt, and tighten
the bolt.
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Apply locking agent to the cable holder bolt threads.
Install the cable holder, ground cable terminal and
holder bolts, and tighten the bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Check the reverse shift actuator cables and adjust
them if necessary (page 19-38).
Install the rear brake master cylinder (page 15-19).
19-50
OST MOTION
SPRING ENDS
ARM SPRING END
ARM SPRING END