Gearshift Spindle Assembly - Honda GL1800 Service Manual

GEARSHIFT LINKAGE/TRANSMISSION
Apply locking agent to the setting plate bolt threads.
Install the setting plate with the "OUTSIDE" mark
facing out and tighten the two bolts.
TORQUE: 26 N·m (2.7 kgf·m, 20 lbf·ft)

GEARSHIFT SPINDLE ASSEMBLY

Apply engine oil to the needle bearings (four
places).
Pack grease into the seal lip cavity of a new oil seal
and install it into the crankcase.
Install gearshift spindle A, being careful not to dam-
age the oil seal lips.
Install the thrust washer onto gearshift spindle B.
Place the spindle arm through the notch in spindle
A with the flat surface of the arm facing in. Then
insert spindle B through the crankcase and spindle
A, align the spring ends with the spring pin.
Align the bolt holes in the spindle arm and spindle
B, and install a new lock washer and the bolt.
Tighten the bolt.
TORQUE: 25 N·m (2.5 kgf·m, 18 lbf·ft)
Bend the lock tabs up against the bolt head.
Assemble the crankcase halves (page 11-22).
10-38
OCK WASHER
BO T