Honda GL1800 Service Manual page 425

FRONT WHEEL/SUSPENSION/STEERING
Install a new slider bushing if the bushing has been
Be careful not to
removed.
damage the coat-
ing of the bushing.
Do not spread open
• Remove the burrs from the bushing mating sur-
the bushing more
face, being careful not to peel off the coating.
than necessary.
Install the guide bushing and install the back-up ring
with its chamfered surface side facing down.
Apply fork fluid to a new oil seal lip.
Install the oil seal with the marks side facing up.
Install the rebound spring onto the fork piston.
Install the fork piston into the fork tube.
Install the following:
– stopper ring
– spring seat
– oil lock spring
– oil lock valve
– stopper ring
Install the fork tube into the fork slider.
Hold the fork slider in a vise with soft jaws or a shop
If the fork piston
towel.
turns with the cen-
Apply locking agent to the center bolt threads.
ter bolt, tempo-
Install the center bolt with a new sealing washer
rarily install the fork
and tighten it to the specified torque.
spring, spring seat,
spacer and fork
TORQUE: 20 N·m (2.0 kgf·m, 14 lbf·ft)
cap.
Drive the oil seal into the fork slider until the stopper
ring groove is visible using the special tool.
TOOL:
Fork seal driver, 45 mm
13-30
GUIDE BUSHING
SPRING
IL L CK VALVE
07KMD-KZ30100 or
07KMD-KZ3010A
(U.S.A. only)
IL SEAL
BACK-UP RING
SLIDER BUSHING
SPRING SEAT
EALING WA HER
CENTER BOLT
ST PPER RINGS