Rear Brake; Brake Pad Wear - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

ASTING LEDGE

If the fluid level is near the "LOWER" level mark,

remove the reservoir cap, set plate and diaphragm,

and fill the reservoir with DOT 4 brake fluid from a

sealed container to the casting ledge.

Install the diaphragm, set plate and reservoir cap

and tighten the cap screws.

TORQUE: 2 N·m (0.2 kgf·m, 1.4 lbf·ft)

REAR BRAKE

Place the motorcycle on its center stand on a level

Remove the right engine side cover (page 2-5).

Check the fluid level in the rear brake reservoir.

If the level is near the "LOWER" level line, remove

the reservoir cap, set plate and diaphragm, and fill

the reservoir with DOT 4 brake fluid from a sealed

container to the "UPPER" level line.

Install the diaphragm, set plate and reservoir cap.

Install the right engine side cover (page 2-5).

Check the brake pads for wear.

Replace the brake pads if either pad is worn to the

bottom of the wear limit groove.

Refer to page 15-13 for brake pad replacement.

WEAR LIMIT GROOVES