CYLINDER/PISTON/CRANKSHAFT
BEARING INSTALLATION
Clean the bearing outer surfaces, bearing caps and
connecting rods.
Install the crankpin bearing inserts onto the bearing
EARING INSERTS
caps and connecting rods, aligning each tab with
each groove.
TA AND GROOVE
CRANKSHAFT REMOVAL
Remove the piston/connecting rod assemblies of
M IN JOURN L BE RING C P BOLT
the right cylinder and the bearing caps on the left
cylinder connecting rod (page 11-7).
Before loosening the bearing cap bolts, punch each
bolt flange and main journal bearing cap at the
LIGNING
same position to indicate the aligning point for
M RKS
tightening the bolts during reassembly.
• Mark the bearing cap bolts and bearings as you
remove them to indicate the correct journals.
Remove the bolts and the main journal bearing
Do not forcibly
caps.
remove the dowel
pins from the bear-
ing caps.
EARING CAPS
Move the left crankcase pistons to the top of the
bores to avoid damaging the crankshaft with the
connecting rod bolts.
RANKSHAFT
Remove the crankshaft.
ONNE TING RODS
11-13