Power Trunk Lock System; Transmitter Registration - Honda GL1800 Service Manual

LIGHTS/METERS/SWITCHES

POWER TRUNK LOCK SYSTEM

• The turn signal lights blink twice when the trunk
opener unit is unlocked using the transmitter
with the ignition switch turned to "OFF" or
"LOCK."
• The turn signal lights blink once when the trunk
opener unit is locked using the transmitter with
the ignition switch turned to "OFF" or "LOCK."
• The horns sound twice and the turn signal lights
blink twice when the "CALL" button is pushed
for more than 0.5 second.
• The trunk opener unit can be unlocked or locked
using the transmitter with the ignition switch
turned to "ON" or "ACC," but the turn signal
lights do not blink.
• The "POP UP" and "CALL" functions do not
work with the ignition switch turned to "ON" or
"ACC."
• If any of the lids are open, the trunk opener unit
cannot be locked using the transmitter and the
turn signal lights blink ten times when the lock
button is pushed.
• If the trunk opener unit is unlocked using the
transmitter but any of the lids is not opened
within
automatically.

TRANSMITTER REGISTRATION

• The codes of up to three transmitters can be reg-
istered into the trunk lock control unit memory.
(If a fourth code is stored, the code which was
registered first will be erased.)
• Make sure to keep the timing between 1 and
4 seconds for each action. Too fast or too slow
will cause the control unit to lose the stored
codes.
1. Turn the ignition switch to "ON." Between 1 and
4 seconds, press the trunk opener button on the
transmitter while aiming transmitter at the trunk.
Between 1 and 4 seconds, turn the ignition
switch to "OFF."
2. Between 1 and 4 seconds, turn the ignition
switch back to "ON." Between 1 and 4 seconds,
press the trunk opener button on the transmitter
while aiming transmitter at the trunk. Between 1
and 4 seconds, turn the ignition switch to "OFF."
3. Between 1 and 4 seconds, turn the ignition
switch back to "ON." Between 1 and 4 seconds,
press the trunk opener button on the transmitter
while aiming transmitter at the trunk. Between 1
and 4 seconds, turn the ignition switch to "OFF."
4. Between 1 and 4 seconds, turn the ignition
switch back to "ON." Between 1 and 4 seconds,
press the trunk opener button on the transmitter
while aiming transmitter at the trunk. Confirm
that the turn signal lights blink twice. Leave the
ignition switch "ON."
5. Within 10 seconds, aim the transmitters (up to
three) that you want to store codes in at the trunk
and press the trunk opener button once on each
transmitter. Confirm that the turn signal lights
blink twice. Turn the ignition switch to "OFF."
20-42
30 seconds, the trunk is locked
RUNK OPENER
(POP UP) BU ON
CALL BU ON
RUNK OPENER
BU ON