Power Control Relay 2 - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:
Table of Contents

Advertisement

STARTER/REVERSE SYSTEM
2. Turn the ignition switch to "OFF."
Exchange power control relay 1 with the other
Power control relay
good one and check again.
1 is the same part
as power control
• If the relay clicks, replace power control relay
relay 2 and the
1 with a new one and go to step 3.
speed limiter relay.
• If the relay does not click, check the following:
– open circuit in the Orange wire between
– open circuit in the White/blue wire between
3. Turn the ignition switch to "OFF" and disconnect
the reverse resistor connector.
With the jumper wire ground, turn the ignition
switch to "ON."
Check for continuity between the Red and Black
wire terminals of the wire harness side reverse
resistor connector.
There should be continuity.
• If there is no continuity, check for open circuit
in Red and Black wires between power control
relay 1 and reverse resistor.

POWER CONTROL RELAY 2

1. Ground the White wire terminal of the control
module connector with a jumper wire.
Turn the ignition switch to "ON" and check that
power control relay 2 clicks.
• If the relay clicks, the relay coil is normal; go
to step 3.
• If the relay does not click, go to step 2.
2. Turn the ignition switch to "OFF."
Exchange power control relay 2 with a known-
Power control relay
good one and check again.
2 is the same part
as power control
• If the relay clicks, replace power control relay
relay 1 and the
2 with a new one and go to step 3.
speed limiter relay.
• If the relay does not click, check the following:
– open circuit in the White wire between
– open circuit in the White/blue wire between
19-32
power control relay 1 and cruise/reverse
control module
power control relay 1 and reverse shift
actuator (reverse position switch)
power control relay 2 and the cruise/
reverse control module
power control relay 2 and reverse shift
actuator (reverse position switch)
OWER CONTROL RELAY 1
REVERSE RESISTOR CONNECTOR
CONTROL MODULE 26P GRAY CONNECTOR
(viewed from the terminal side)
OWER CONTROL RELAY 2
hite

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gl1800a

Table of Contents