Honda GL1800 Service Manual page 606

STARTER/REVERSE SYSTEM
GEAR CASE UG AND
Install the washer.
Install the gear base and gear base washer, aligning
GROOVE
the grooves with the motor case lug.
Install a new seal ring.
Install the reduction gear case, aligning the groove
in the large outer gear with the motor case lug.
SEA RING GEAR BASE
ASE BOLTS
Install the three case bolts and tighten them
securely.
INSTALLATION
Coat a new O-ring with oil and install it into the
starter/reverse motor groove.
Install the starter/reverse motor into the rear crank-
case cover as shown.
Install the three mounting bolts and tighten them.
TORQUE: 29 N·m (3.0 kgf·m, 22 lbf·ft)
Connect the starter motor cable.
Install and tighten the terminal nut securely.
Pull the rubber cap onto the terminal securely.
Install the following:
– reverse shift arm (page 19-49)
– fuel tank (page 5-56).
19-23