Honda GL1800 Service Manual page 324

Temporarily install the clutch outer onto the pri-
mary driven gear boss.
Hold the clutch outer with the special tool and
loosen the oil pump driven sprocket bolt.
TOOL:
Clutch outer holder
Remove the clutch outer.
Remove the following:
– driven sprocket bolt
– driven sprocket, drive chain and primary driven
gear boss as a set
– two bolts and oil separation plate (if necessary)
Check the driven gear boss bearing for wear or
damage.
Unstake the final drive gear lock nut with a drill or
Be careful not to
grinder.
damage the
countershaft
threads.
Shift the transmission into any forward gear except
The final drive gear
neutral.
lock nut has left-
Hold the mainshaft with the special tool and loosen
hand threads.
the lock nut.
TOOL:
Shaft holder
Remove the following:
– lock nut
– washer
– final drive gear
GEARSHIFT LINKAGE/TRANSMISSION
07JMB-MN50100
HAFT HOLDER
07JMB-MN50200
OLT
nstake
LOCK NUT (left-hand
threads) AND WA HER
FINAL DRIVE GEAR
CLUTCH
OUTER
HOLDER
10-15