Honda GL1800 Service Manual page 418

Hide thumbs Also See for GL1800:

Table of Contents

Install the right front brake caliper with new mount-

ing bolts so the disc is positioned between the pads,

being careful not to damage the pads. Tighten the

mounting bolts.

TORQUE: 31 N·m (3.2 kgf·m, 23 lbf·ft)

Install the speed sensor wire clamp and tighten the

Apply grease to the lower pivot bearing and dust

seal lips, and to the outer surface of the upper pivot

Install the pivot collars into the fork and caliper

Install the left front brake caliper with new mounting

bolts (lower pivot and upper joint bolts) and tighten

TORQUE: Pivot bolt: 31 N·m (3.2 kgf·m, 23 lbf·ft)

Joint bolt: 25 N·m (2.6 kgf·m, 19 lbf·ft)

Remove the protective tape.

With the front brake applied, pump the forks up and

down several times to seat the axle and check brake

Tighten the left axle holder bolts to the specified

TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)

FRONT WHEEL/SUSPENSION/STEERING

EFT AX E HO DER BO TS

ALIPER MOUNTING BOLTS

Troubleshooting