Lights/Meters/Switches Service Information; Lights/Meters/Switches Torque Values; Lights/Meters/Switches Tool - Honda GL1800 Service Manual

SERVICE INFORMATION
GENERAL
A halogen headlight bulb becomes very hot while the headlight is on, and remains hot for a while after it is turned off. Be
sure to let it cool down before servicing.
• Use an electric heating element to heat the water/coolant mixture for the thermosensor inspection. Keep all flammable
materials away from the electric heating element. Wear protective clothing, insulated gloves and eye protection.
• Note the following when replacing the halogen headlight bulb.
– Wear clean gloves while replacing the bulb. Do not put fingerprints on the headlight bulb, as they may create hot
spots on the bulb and cause it to fail.
– If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent an early failure.
– Be sure to install the dust cover after replacing the bulb.
• Check the battery condition before performing any inspection that requires proper battery voltage.
• A continuity test can be made with the switches installed on the motorcycle.
• When checking the turn signal/hazard system, always follow the steps in the troubleshooting flow chart (page 20-5).
• The following color codes used are indicated throughout this section.
Bl: Black G: Green
Br: Brown Gr: Gray
Bu: Blue Lb: Light Blue
SPECIFICATIONS
Bulbs
Fuse
ECT sensor resistance
TORQUE VALUES
Side stand switch bolt
Ignition switch mounting bolt
TOOL
IgnitionMate peak voltage tester
MTP07-0286 (U.S.A. only)
Lg: Light Green
O: Orange
P: Pink
ITEM
Headlight (high beam)
Headlight (low beam)
Brake/taillight
License light
Front turn signal/running light
Rear turn signal light
Main fuse A
Main fuse B
Reverse speed limiter fuse
Sub-fuse
Modulator fuse (ABS model)
At 80° C (176° F)
At 120° C (248° F)
12 N·m (1.2 kgf·m, 9 lbf·ft)
25 N·m (2.5 kgf·m, 18 lbf·ft)
Peak voltage adaptor
07HGJ-0020100
(not available in U.S.A.) with com-
mercially available digital
multimeter (impedance 10 MΩ/DCV
minimum)
LIGHTS/METERS/SWITCHES
R: Red
W: White
Y: Yellow
SPECIFICATIONS
12 V – 55 W x 2
12 V – 55 W x 2
12 V – 21/5 W x 6
12 V – 3CP (5W)
12 V – 21/5 W x 2
12 V – 21 W x 2
30A
100A
70A
20A x 3, 15A x 8, 10A x 3, 5A x 4 (ABS model:
5A x 5)
30 A x 2
47 – 57Ω
14 – 18Ω
Fuel sender/pump wrench
07ZMA-MCAA201 (U.S.A. only)
or 07ZMA-MCAA200 (U.S.A. only)
20-3