Honda GL1800 Service Manual page 454

6. Angle Sensor Signal
Combination Meter
Measure the angle sensor resistance between
the Yellow/red and Blue/green wire terminals of
the combination meter 16P black connector.
STANDARD: 0.4 – 5.4 kΩ (20° C/68° F)
Is the resistance within the specified value?
NO – GO TO STEP 9.
YES – GO TO STEP 7.
7. Actuator Motor Operation Inspection at Suspen-
sion Level Relays
Remove the suspension level UP and DOWN
relays (page 14-29).
Check the actuator motor operation by connect-
ing a fully charged 12-V battery.
• If the angle sensor resistance measured on
the previous step is 2.5 kΩ or more:
Connect the battery positive (+) terminal to
the UP relay connector Brown/white wire ter-
minal and the battery negative (–) terminal to
the DOWN relay connector Green wire termi-
nal within 3 seconds (max. 3 seconds).
• If the angle sensor resistance measured on
the previous step is 2.5 kΩ or less:
Connect the battery positive (+) terminal to
the DOWN relay connector Green wire termi-
nal and the battery negative (–) terminal to
the UP relay connector Brown/white wire ter-
minal within 3 seconds (max. 3 seconds).
Do not connect the battery to the connector ter-
minals for more than 3 seconds.
Does the actuator motor operate when con-
nected as described above?
NO – GO TO STEP 12.
YES – GO TO STEP 10.
Line Inspection at
REAR WHEEL/SUSPENSION
Bu/G
Y/R
ETER 16P BLACK CONNECTOR
(viewed from the terminal side)
r/W
UP RELAY CONNECTOR
DOWN RELAY CONNECTOR
14-9