Honda GL1800 Service Manual page 688
Hide thumbs
Also See for GL1800:
- Owner's manual (251 pages) ,
- Setup instructions (32 pages) ,
- Quick start manual (5 pages)
Table of Contents
Advertisement
7. Combination Meter and Cruise/Reverse Module
Remove the combination meter (page 20-17).
Check the Blue-orange wire for continuity
between the meter 20P blue connector and
cruise/reverse
control
connector.
Is there continuity?
NO
– • Open circuit in the Blue/orange wire.
• Loose or poor contact of the related
connectors.
YES
– GO TO STEP 8.
8. Combination Meter Voltage
Turn the ignition switch to "ON." Measure the voltage between the Black/yellow wire terminal (+) of
the meter 20P blue connector and ground.
Is there battery voltage?
NO
– Open circuit in the Black/yellow wire between the combination meter and ignition cruise
relay.
YES
– Faulty meter/gauge assembly; replace it (page 20-19).
Cruise "ON" indicator blinks when the cruise main switch is pushed to "ON"
1. Relay Coil Line
• If the cruise actuator relay is faulty, the system will enter the fail-safe mode, and the cruise "ON"
indicator will blink when the cruise main switch is pushed to "ON" with the ignition switch turned
to "ON and the engine stop switch to " ."
Check the cruise actuator relay coil (No. 50) line at the cruise/reverse control module.
Does the relay coil (No. 50) line function as specified?
NO
– • Faulty cruise actuator relay (page 21-16).
• Open circuit in the Black/yellow wire between the ignition cruise and actuator relays.
• Open or short circuit in the Green/black wire between the cruise/reverse control module
and cruise actuator relay.
YES
– GO TO STEP 2.
2. Cruise Actuator Relay Signal Line
Check the cruise actuator relay signal (No. 32) line at the cruise/reverse control module (page 21-9).
Does the cruise actuator relay signal (No. 32) line function as specified?
NO
– • Faulty cruise actuator relay (page 20-16).
• Open circuit in the Black/yellow wire between the ignition cruise and actuator relays.
• Open circuit in the Brown/white wire between the cruise/reverse control module and
cruise actuator relay.
YES
– Faulty cruise/reverse control module.
module
26P
black
CRUISE CONTROL SYSTEM
WIRE HARNESS SIDE COM INATION
METER 20P LUE CONNECTOR
(viewed from the terminal side)
lue/orange
lack/yellow
21-5
Advertisement
Table of Contents
Troubleshooting
